Resource Center Tools

Sign In

Sign In

Home
Resources
Trouble Codes
Notifier
Nfs2 640
Gndflt

Resource Center

Browse

Home Questions252 Trouble Codes688 Panels24 Panel Specs24

Learn

Community

Tools

Common Categories

System TroubleSupervisoryGround FaultNACCommunicationPowerDeviceNetwork

Troubleshooting Tip

When diagnosing codes, always check the event history log first. Many trouble conditions are intermittent and tied to environmental factors like temperature or moisture.

Recommended SupplierSponsored

Fire Alarm Parts for Old and New Systems

Panels, detectors, modules and signals
50+ brands, current and legacy
Order by 3 pm ET, ships same day
90-day warranty on every part

Shop Fire Alarm Parts

Can't find what you need?

Resource Center

Questions Panels Trouble Codes Panel Specs NFPA 72-2025

Legal

Privacy Policy Terms of Use Disclaimer DMCA

Cookie Preferences

Company

About Us Blog Glossary Contact Us

© FACP Manuals LLC. All rights reserved.

Built by Will

GNDFLT: NFS2-640 Trouble Code | Fire Alarm Resource Center

GNDFLT

trouble

Notifier NFS2-640

72 views·0 field notes

What This Code Means

There is a ground fault on the main or auxiliary power supply.

Common Causes

1Ground fault on the main power supply
2Ground fault on the auxiliary power supply

Resolution Steps

Correct the fault.

Manual References(2)

1notifierNFS2-640Operations2013p. 72Open

2notifierNFS2-640Datasheet2017Open

Field Notes

Loading field notes...

Sign in to share a field note

Related Codes

INVREPThe device has returned a response to the panel that the panel did not expect.INST ON L1No devices are installed on the system.LO VALThe detector chamber reading is too low, or the detector is not operating properly. In CLIP mode, this may also indicate a failure of the thermistors, CO element, or infra-red element, or a freeze warning.PREALMThe control panel activates a Pre-Alarm Warning when a detector exceeds its programmed Pre-Alarm Alert or Action level, providing an early warning of incipient or potential fire conditions.NETWORK FAIL PORT xCommunication lost between NCM Port x and corresponding node.

Related Questions

What is the maximum device capacity on the NFS2-640 in FlashScan mode vs. CLIP mode, and can you mix protocols on the same SLC loop?How do I troubleshoot a ground fault on the NFS2-640 SLC loop?What are the NAC circuit specifications for the NFS2-640, and when do I need an external NAC booster panel?

All NFS2-640 trouble codes NFS2-640 panel page