MASTER BOX TROUBLE

trouble

Notifier NFS2-640

50 views·0 field notes

What This Code Means

A TM-4 connected to a municipal box is in trouble.

Common Causes

1Fault in the TM-4 module
2Wiring issue between the TM-4 and the municipal box
3Trouble condition at the municipal box

Resolution Steps

Inspect the TM-4 module and its connection to the municipal box to identify and correct the fault condition.

Manual References(1)

1notifierNFS2-640Operations2013p. 74Open

Field Notes

Loading field notes...

Sign in to share a field note

Related Codes

INVREPThe device has returned a response to the panel that the panel did not expect.LO VALThe detector chamber reading is too low, or the detector is not operating properly. In CLIP mode, this may also indicate a failure of the thermistors, CO element, or infra-red element, or a freeze warning.INST ON L1No devices are installed on the system.PREALMThe control panel activates a Pre-Alarm Warning when a detector exceeds its programmed Pre-Alarm Alert or Action level, providing an early warning of incipient or potential fire conditions.TROUBLThe system enters System Trouble mode when the control panel detects an electrical fault or a trouble condition on a supervised circuit or module.

Related Questions

What is the maximum device capacity on the NFS2-640 in FlashScan mode vs. CLIP mode, and can you mix protocols on the same SLC loop?How do I troubleshoot a ground fault on the NFS2-640 SLC loop?What are the NAC circuit specifications for the NFS2-640, and when do I need an external NAC booster panel?

All NFS2-640 trouble codes NFS2-640 panel page