Resource Center Tools

Sign In

Sign In

Home
Resources
Trouble Codes
Edwards Est
Est4
Alarm

Resource Center

Browse

Home Questions252 Trouble Codes688 Panels24 Panel Specs24

Learn

Community

Tools

Common Categories

System TroubleSupervisoryGround FaultNACCommunicationPowerDeviceNetwork

Troubleshooting Tip

When diagnosing codes, always check the event history log first. Many trouble conditions are intermittent and tied to environmental factors like temperature or moisture.

Recommended SupplierSponsored

Fire Alarm Parts for Old and New Systems

Panels, detectors, modules and signals
50+ brands, current and legacy
Order by 3 pm ET, ships same day
90-day warranty on every part

Shop Fire Alarm Parts

Can't find what you need?

Resource Center

Questions Panels Trouble Codes Panel Specs NFPA 72-2025

Legal

Privacy Policy Terms of Use Disclaimer DMCA

Cookie Preferences

Company

About Us Blog Glossary Contact Us

© FACP Manuals LLC. All rights reserved.

Built by Will

Alarm: EST4 Trouble Code | Fire Alarm Resource Center

Alarm

alarm

Edwards EST EST4

75 views·0 field notes

What This Code Means

A life-safety emergency condition has been detected by an initiating device.

Common Causes

1Smoke or heat detection
2Manual pull station activation
3Waterflow switch activation

Resolution Steps

Follow site emergency procedures. Once the area is safe, identify the activated device and reset the panel.

Manual References(2)

1edwards estEST4 Submittal GuideSubmittal Guide2023p. 10, 12, 21Open

2edwards estEST4 User GuideUser Guide2019p. 13, 15, 16, 17, 19 +2Open

Field Notes

Loading field notes...

Sign in to share a field note

Related Codes

TroubleGeneral fault within the system hardware or wiring that prevents normal operation.BuildingControlled building equipment such as dampers, fans, or temperature controls are not operating correctly.Ground faultThe system detects a low resistance path (approximately 10 kΩ or less) between a circuit conductor and earth ground, or voltages outside the range of 12.3 VDC to 16.8 VDC during testing.A short is detected on the loopA shorted circuit has been detected on the Signature loop controller (SLC) wiring, which typically reports a trouble condition on all devices on that circuit.SUPERVISORYThe control unit enters the supervisory state when a point signals a supervisory condition, such as a valve tamper switch activation or a system-level supervision fault.

Related Questions

How do I perform a walk test on the EST4, and can individual SLC loops be isolated for testing?What is the maximum SLC loop length and device count per loop on the EST4?What are the battery sizing requirements for the EST4, and what is the replacement procedure?

All EST4 trouble codes EST4 panel page