Silent Knight

SK-5207

The Silent Knight 5207 is a small addressable fire alarm control panel supporting 1 SLC loop. A cost-effective solution for small commercial applications.

3 manuals33 trouble codesModels: 5207, SK-5207, 5207-4

Specifications

SLC Loops

N/A (Conventional)

Panel Type

Conventional

IDC Zones

8 (expandable to 16)

NAC Circuits

4 Style Y

Battery (Ah)

17-34

Manuals

5207

InstallationOperationsProgramming2003

Trouble Codes

View all 33 →

A1Indicates a trouble condition on notification circuit 1 (bell output 1) or that the power supply and panel voltage selections are not the same.Trouble with specified bell outputA trouble condition exists on the indicated notification (bell) circuit.A2A trouble condition exists on notification circuit 2 (bell output 2), or the power supply and panel voltage selections are not the same.A3

Related Questions

How do I wire Class B vs. Class A zone loops on the SK-5207, and what end-of-line resistor value is required?What does the P3 (Earth Ground Fault) trouble code mean on the SK-5207, and how do I isolate the fault?How do I program Relay 3 on the SK-5207 to activate on all trouble conditions?Which two-wire and four-wire smoke detectors are compatible with the SK-5207?

All Silent Knight manuals →All SK-5207 trouble codes →Ask TroubleShooter AI →

Manuals That Reference This Model (2)

5395Installation1997 5230Datasheet2018

Indicates a trouble condition on notification circuit 3 or that the power supply and panel voltage selections are not the same.

A4A trouble condition exists on notification circuit (bell) number 4, or the power supply and panel voltage selections do not match.

ACThe panel has detected a low AC condition or AC power has been lost.

BUS TROUBLEThe annunciator data wires are shorted or reversed.

dCThe panel has detected a low battery condition.

FAILED DFThe communicator has failed to report an event to the central station after the programmed number of attempts have been made.

DISABLED: ZONE #A zone has been manually disabled or bypassed.

What is the correct walk test procedure on the SK-5207?