How do I connect the iO1000 to an SA-ETH Ethernet card for remote monitoring or network annunciation?

The SA-ETH card connects to the iO1000 main circuit board at connector J1 and provides a 10/100 Base-T connection for remote diagnostics, iO-CU programming, and central station monitoring via Sur-Gard IP receivers (Page 3, 5) [1].

1. Power down the panel by disconnecting batteries, then AC power (Page 1) [1].

2. Slide the card into the slot on the plastic assembly behind the main board and secure it with two #6 plastite screws (Page 1) [1].

3. Connect ribbon cable P/N 7140189 from the card to connector J1 at the top-right of the main board (Page 1) [1].

4. Connect a Cat 5/6 cable (200 ft max run) to the RJ-45 port (Page 2, 40) [1].

5. Power up the panel (AC first, then batteries) and configure IP settings in the Panel programming menu (Page 1, 151) [1].

Default IP settings are 192.168.001.003 with a mask of 255.255.255.000 (Page 2) [1].