How do I set up cause-and-effect programming on the FlexES panel to link detector zones to NAC outputs?

To set up cause-and-effect programming on the FlexES panel, you must use the tools 8000 programming software (version V1.16 or higher). The panel does not support manual address entry, so all logic must be defined in the software and uploaded to the control module (Page 79) [1].

1. Assign individual detectors to the required detector zones using the programming software (Page 76) [1].

2. Configure a control zone for the desired output, such as Relays 2 to 5 which can be configured as monitored outputs for audible devices (Page 65) [1].

3. Define the activation event, such as a specific detector zone, that will trigger the control zone within the software (Page 35) [2].

4. For fire department peripherals, configure the RS485 interface in the customer data using the appropriate log (Page 82) [1].