How do I set up the SA-DACT dialer module in the iO1000 for dual-line DACT reporting using Contact ID format?

Install the SA-DACT module and connect it to the main board via the ribbon cable at J8. In the panel's programming menu, set the CMS device type to Dual Line and the communication format to CID. 1. Power down the panel and install the SA-DACT into the card slot, connecting the ribbon cable to J8 (Page 1) [1].

1. Connect phone lines to J1 and J4; note that manual revisions provide conflicting information on which connector is Line 1, so verify board markings (Page 5, 33) [1].

2. Navigate to Panel Programming > CMS Device > Dialer (Page 144) [1].

3. Set the Type to Dual line and the Format to CID (Page 144, 145) [1].

4. Enter the 4-digit Account ID and the Primary/Secondary Receiver phone numbers (Page 145) [1].

5. Configure Line 1 and Line 2 options, then select Save (Page 146) [1].