How do I use the JumpStart Auto-Programming feature on the Silent Knight 6820 to discover and address all SLC devices?

JumpStart is used to automatically scan and configure devices that have already been addressed and connected to the SLC loops. Note that JumpStart does not assign addresses; you must manually address all devices before running this process (Page 74) [1].

To run the feature: 1. Login to the panel and select 7 for Panel Programming (Page 74) [1].

1. Select 6 for JumpStart AutoProgramming (Page 108) [1].

2. Press ENTER to accept the warning that the system will shut down (Page 74) [1].

3. When the SLC Family message appears, select the protocol being used, such as SK, SD, or IDP, and press ENTER (Page 108) [1].

4. The system will scan the loops for several minutes. When Configuring System Done displays, press any key (Page 74) [1].

5. Press 1 to Review System to verify the discovered devices (Page 74) [1].