[custom message] [device type] IN SUPsupervisory

Siemens MXL: [custom message] [device type] IN SUP

Siemens MXL·1 view·0 field notes

What This Code Means

A condition indicating that a monitored device or system has changed to an off-normal state, which takes priority over security and trouble conditions.

Common Causes

1Activation of a device programmed as a supervisory point
2System supervisory queue is full (More Than 60 Supervisory)
3Sprinkler tamper switch or other system monitoring activation
4Communication failure with a device configured for supervisory monitoring

Resolution Steps

Note the specific location of the supervisories by pressing NEXT on the MKB-4 to view the list. Unlock and open the door, then press SUPV ACK to acknowledge the condition. The SUPERVISORY LED will glow steadily to indicate acknowledgment. Investigate the device at the reported address and restore it to its normal state.

Manual References(1)

1siemensMXL-IQInstallationp. 57, 58, 148, 6, 151, 59, 69, 74, 149, 103, 102, 147, 146, 62, 60, 139, 55, 132Open

Field Notes

Loading field notes...

Related Codes

AC VOLTAGE = X VOLTSDisplay of the current AC input voltage to the system power supply.BATT CHG CUR = XX.X AMPSDisplay of the current being used to charge the system batteries.NN:MMM-DDD [custom message] ACK [trouble type] IN TRBA general system trouble has occurred, indicating a fault that may prevent the system from operating correctly.GROUND FAULT IS OKThe system ground fault test has passed and no ground faults are currently detected.Pre-alarmA smoke detector has reached a threshold near its alarm point but has not yet reached full alarm status.