Fire-Lite MS-9200UDLS Questions
Questions and answers specific to the Fire-Lite MS-9200UDLS.
Sign in to ask a question
Questions and answers specific to the Fire-Lite MS-9200UDLS.
To perform a walk test on the MS-9200UDLS, navigate to the Walktest menu through either the Programming or Maintenance screens and select between a silent or...
To add a remote annunciator such as the ANN-80, you must wire the device to the FACP's ANN-BUS terminals, assign a unique address using the module's DIP...
To wire a 4-wire smoke detector, connect the detector's power terminals to the Resettable Power output (TB1 terminals 3 and 4), which provides 24 VDC filtered...
The MS-9200UDLS uses sealed lead-acid batteries with a minimum capacity of 7 AH (Page 15) [1]. The standard control panel cabinet is designed to house and...
INVREP indicates an invalid reply from an addressable device, which typically points to a hardware or communication problem (Page 131, 136) [1]. This...
The MS-9200UDLS is completely field programmable from the front panel keypad and does not require PS-Tools software for setup (Page 65) [1]. You can also...
The MS-9200UDLS features four onboard Notification Appliance Circuits (NACs) that provide 24 VDC nominal special application power (Page 15) [1]. Each circuit...
The MS-9200UDLS has a maximum capacity of 198 addressable devices, consisting of 99 detectors and 99 control or monitor modules (Page 91) [1]. LiteSpeed is the...
The UDLS suffix indicates the panel supports Upload/Download (UD) capabilities and utilizes the LiteSpeed (LS) polling protocol for faster device response...
To troubleshoot a ground fault, identify the condition by the flashing yellow Ground Fault LED, which indicates zero impedance from the FACP to ground (Page...