Resource Center Tools

Sign In

Sign In

Home
Resources
Trouble Codes
Edwards Est
Io1000
069

Resource Center

Browse

Home Questions252 Trouble Codes688 Panels24 Panel Specs24

Learn

Community

Tools

Common Categories

System TroubleSupervisoryGround FaultNACCommunicationPowerDeviceNetwork

Troubleshooting Tip

When diagnosing codes, always check the event history log first. Many trouble conditions are intermittent and tied to environmental factors like temperature or moisture.

Recommended SupplierSponsored

Fire Alarm Parts for Old and New Systems

Panels, detectors, modules and signals
50+ brands, current and legacy
Order by 3 pm ET, ships same day
90-day warranty on every part

Shop Fire Alarm Parts

Can't find what you need?

Resource Center

Questions Panels Trouble Codes Panel Specs NFPA 72-2025

Legal

Privacy Policy Terms of Use Disclaimer DMCA

Cookie Preferences

Company

About Us Blog Glossary Contact Us

© FACP Manuals LLC. All rights reserved.

Built by Will

Internal fault: iO1000 Trouble Code | Fire Alarm Resource Center

Internal fault

trouble

Edwards EST iO1000

110 views·0 field notes

What This Code Means

The control panel detected an internal hardware or software error

Common Causes

1Processor malfunction
2Internal communication error
3Software glitch

Resolution Steps

Perform a system reset. If the error returns, contact technical support for board replacement.

Manual References(3)

1edwards estiO64 and iO1000Datasheet2020p. 1Open

2edwards estiO64 and iO1000Datasheet2023p. 1Open

3edwards estiO64 and iO1000Installation2015p. 186, 160, 61, 187, 189 +2Open

Field Notes

Loading field notes...

Sign in to share a field note

Related Codes

Dialer delivery failThe dialer failed to deliver a message to the receiver Dialer line 1 faultA ground fault or line fault was detected on line 1 of the dialer Loop 1 uncfgrd troubleA device on loop 1 that is not programmed went into trouble SupervisoryA supervisory event is taking place on the control panel, indicating an off-normal condition on a monitored circuit or device.Loop 1 map mismatchThe loop 1 map in RAM and the loop 1 map in the database do not match

Related Questions

How do I address devices on the iO1000?How do I set up the SA-DACT dialer module in the iO1000 for dual-line DACT reporting using Contact ID format?What Signature series devices are compatible with the iO1000 SLC loop, and can I mix legacy and newer devices on the same loop?

All iO1000 trouble codes iO1000 panel page