A short or open was detected on the loop affecting the communications between the panel and the devices on the loop.

There is a problem with the panel’s AC power

An open or short was detected on annunciator 1

The panel detected a battery charger trouble condition

The batteries are low

The battery is no longer connected

A disable event is taking place on the control panel, indicating that a device, zone, or panel event has been manually deactivated.

The dialer failed to deliver a message to the receiver

A ground fault or line fault was detected on line 1 of the dialer

The panel detected a ground fault

The control panel detected an internal hardware or software error

IP Gateway configuration is invalid

A device on loop 1 has an address set to zero

The loop 1 map in RAM and the loop 1 map in the database do not match

There are too many devices on loop 1

A device on loop 1 that is not programmed went into trouble

The loop 2 card is not present or it is not working

A short or open was detected on loop 2 affecting the communications between the panel and the devices

A device on loop 2 that is not programmed went into alarm

An open or short was detected on NAC 1 or there is a problem with the EOL

The printer is either offline, out of paper, or disconnected

A fault was detected while testing the panel’s internal subsystems (memory, flash, code)

A supervisory event is taking place on the control panel, indicating an off-normal condition on a monitored circuit or device.

A supervisory condition has been activated

An input device programmed as a waterflow type has been activated, typically indicating water movement within the sprinkler system.

A maintenance alert was detected in the zone

A short or open was detected on the loop affecting the communications between the panel and the devices on the loop.

There is a problem with the panel’s AC power

An open or short was detected on annunciator 1

The panel detected a battery charger trouble condition

The batteries are low

The battery is no longer connected

A disable event is taking place on the control panel, indicating that a device, zone, or panel event has been manually deactivated.

The dialer failed to deliver a message to the receiver

A ground fault or line fault was detected on line 1 of the dialer

The panel detected a ground fault

The control panel detected an internal hardware or software error

IP Gateway configuration is invalid

A device on loop 1 has an address set to zero

The loop 1 map in RAM and the loop 1 map in the database do not match

There are too many devices on loop 1

A device on loop 1 that is not programmed went into trouble

The loop 2 card is not present or it is not working

A short or open was detected on loop 2 affecting the communications between the panel and the devices

A device on loop 2 that is not programmed went into alarm

An open or short was detected on NAC 1 or there is a problem with the EOL

The printer is either offline, out of paper, or disconnected

A fault was detected while testing the panel’s internal subsystems (memory, flash, code)

A supervisory event is taking place on the control panel, indicating an off-normal condition on a monitored circuit or device.

A supervisory condition has been activated

An input device programmed as a waterflow type has been activated, typically indicating water movement within the sprinkler system.

A maintenance alert was detected in the zone