ACTIVE SUPERVISORYsupervisory

Fire-Lite MS-9600: ACTIVE SUPERVISORY

Fire-Lite MS-9600·2 views·0 field notes

What This Code Means

A condition indicating a state that needs attention but is not an alarm, such as a sprinkler valve tamper condition.

Common Causes

1Sprinkler valve tamper condition
2Activation of a monitor module programmed as Supervisory
3Tamper switch activation

Resolution Steps

Press the Acknowledge/Step or Alarm Silence key to silence the pulsing piezo sounder. Identify the device address and type from the LCD display. Correct the condition at the field device (e.g., restore the tamper switch). Press the System Reset key to clear the supervisory condition from the panel.

Manual References(3)

1fire-liteMS-9600/MS-9600EInstallation2008p. 7, 114, 116, 113, 10, 112, 125, 157Open

2fire-liteMS-9600LS and MS-9600UDLSInstallation2015p. 7, 109, 131, 79, 160, 129Open

3fire-liteMS-9600LS and MS-9600UDLSDatasheet2019Open

Field Notes

Loading field notes...

Related Codes

AC LOSSThe control panel has lost its primary AC power supply and is currently operating on standby batteries.DISABLIndicates that a zone, NAC, detector, or module has been temporarily disabled in programming by the user.EARTH FAULTA ground fault condition indicating zero impedance between the Fire Alarm Control Panel and ground.Type-Code MismatchThe physical device installed at an address does not match the device type defined in the panel's memory.NAC FaultA problem has been detected on one of the Notification Appliance Circuits.