FACP Manuals Logo
FACPManuals
Ask AI
Ask AI
DISABLtrouble

Fire-Lite MS-9600: DISABL

Fire-Lite MS-9600·1 view·0 field notes

What This Code Means

Indicates that a zone, NAC, detector, or module has been temporarily disabled in programming by the user.

Common Causes

  • 1A software zone has been manually disabled
  • 2An addressable detector has been manually disabled
  • 3An addressable module has been manually disabled
  • 4A Notification Appliance Circuit (NAC) has been manually disabled

Resolution Steps

Access the Maintenance Programming mode by pressing the Enter key, then press 2 and enter the Maintenance level password (default 11111). To enable a point, press 1 for Point Program, select the Loop, select the device type (detector or module), enter the three-digit device address, and change the status to enabled. To enable a zone, navigate to Zone Setup and select the zone number to be enabled.

Manual References(3)

Field Notes

Loading field notes...
Sign in to share a field note

Related Codes

EARTH FAULTA ground fault condition indicating zero impedance between the Fire Alarm Control Panel and ground.Program CheckThe system has identified a logical error in the site programming.Duplicate AddressThe system has detected more than one device sharing the same SLC address.ACTIVE SUPERVISORYA condition indicating a state that needs attention but is not an alarm, such as a sprinkler valve tamper condition.Type-Code MismatchThe physical device installed at an address does not match the device type defined in the panel's memory.

Related Questions

How do I set zone types on the MS-5024?What is the maximum SLC loop capacity of the MS-5024, and which Fire-Lite detectors and modules are compatible?How do I troubleshoot a Loop Fault or SLC Communication Failure on the MS-5024?
All MS-9600 trouble codesMS-9600 panel page