LOOP CONTINUITY TEST FAIL LOOP 1-10trouble

Notifier INSPIRE N16: LOOP CONTINUITY TEST FAIL LOOP 1-10

Notifier INSPIRE N16·0 views·0 field notes

What This Code Means

The panel detected a break in the SLC loop wiring during a continuity test.

Common Causes

1Open circuit in loop wiring
2Loose terminal connection

Resolution Steps

Trace the loop wiring to find the break and restore continuity.

Manual References(1)

1notifierN16Installation2025Open

Field Notes

Loading field notes...

Sign in to share a field note

Related Codes

SELF TEST FAILEDAn automated diagnostic test on a detector or module has failed.ASPIRATIONA supervisory condition reported by an intelligent aspiration (air sampling) detector.MAPPING IN PROGRESS LOOP 1-9The panel is currently performing a topology map of the SLC loop.UNPROGRAMMED DEVICE ON LOOP 1-10A device is physically present on the SLC loop but has not been added to the panel's database.Battery Low (LSB is PMB address 1-5)The backup battery voltage has dropped below the required threshold.

Related Questions

How does the NFW2-100 ground fault detection work?What battery size does the NFW2-100 require, and how do I silence a battery trouble condition after replacement?What batteries does the NFS-320 use, and when is an external battery box required?

All INSPIRE N16 trouble codes INSPIRE N16 panel page