INSPIRE N16 Trouble Codes

Loss of primary AC power to the power supply module.

Two or more devices on the AIO bus share the same address.

Communication failure between the main panel and an AIO peripheral device.

A supervisory condition reported by an intelligent aspiration (air sampling) detector.

The backup battery voltage has dropped below the required threshold.

The cellular card is present but cannot connect to the cellular network.

The power supply's battery charging circuit is not functioning correctly.

The panel is running on a factory default database and has not been configured.

A hardware memory failure detected during the panel's self-diagnostic routine.

An unintentional connection between the system wiring and earth ground.

The system event history log is reaching its maximum capacity.

The panel detected a break in the SLC loop wiring during a continuity test.

The panel is currently performing a topology map of the SLC loop.

The internal battery that maintains the panel's non-volatile memory is low.

The panel enclosure door is open or the tamper switch is activated.

The panel has lost the dial tone or connection on the primary telephone line.

The primary amplifier has detected an overcurrent condition on its output.

An automated diagnostic test on a detector or module has failed.

Excessive data errors detected on the SLC loop, indicating poor signal quality.

A device is physically present on the SLC loop but has not been added to the panel's database.