Resource Center Tools

Sign In

Sign In

Home
Resources
Trouble Codes
Notifier
N16
Pots Line 1 Failure

Resource Center

Browse

Home Questions252 Trouble Codes688 Panels24 Panel Specs24

Learn

Community

Tools

Common Categories

System TroubleSupervisoryGround FaultNACCommunicationPowerDeviceNetwork

Troubleshooting Tip

When diagnosing codes, always check the event history log first. Many trouble conditions are intermittent and tied to environmental factors like temperature or moisture.

Recommended SupplierSponsored

Fire Alarm Parts for Old and New Systems

Panels, detectors, modules and signals
50+ brands, current and legacy
Order by 3 pm ET, ships same day
90-day warranty on every part

Shop Fire Alarm Parts

Can't find what you need?

Resource Center

Questions Panels Trouble Codes Panel Specs NFPA 72-2025

Legal

Privacy Policy Terms of Use Disclaimer DMCA

Cookie Preferences

Company

About Us Blog Glossary Contact Us

© FACP Manuals LLC. All rights reserved.

Built by Will

POTS Line 1 Failure: INSPIRE N16 Trouble Code | Fire Alarm Resource Center

POTS Line 1 Failure

trouble

Notifier INSPIRE N16

66 views·0 field notes

What This Code Means

The panel has lost the dial tone or connection on the primary telephone line.

Common Causes

1Telco line outage
2Disconnected RJ31X jack
3Faulty DACT

Resolution Steps

Verify the telephone line is active using a butt-set and check connections at the panel.

Manual References(1)

1notifierN16Installation2025Open

Field Notes

Loading field notes...

Sign in to share a field note

Related Codes

Cellular Card No ConnectivityThe cellular card is present but cannot connect to the cellular network.AIO Addr 1-10 Duplicate AddressTwo or more devices on the AIO bus share the same address.SELF TEST FAILEDAn automated diagnostic test on a detector or module has failed.AIO Address 1-10 Comm LossCommunication failure between the main panel and an AIO peripheral device.Charger Fail (LSB is PMB address 1-5)The power supply's battery charging circuit is not functioning correctly.

Related Questions

How do I wire and configure ACM-30 annunciators on the N16, and what is the maximum number supported?How do I set detector sensitivity levels on the N16, including automatic day/night sensitivity adjustment?How do I configure the N16 SLC loop for Class A vs. Class B wiring, and what is the maximum loop impedance allowed?

All INSPIRE N16 trouble codes INSPIRE N16 panel page