TRANSMIT/ RECEIVE ERROR ABOVE LIMIT ON LOOP 1-10

trouble

Notifier INSPIRE N16

62 views·0 field notes

What This Code Means

Excessive data errors detected on the SLC loop, indicating poor signal quality.

Common Causes

1Electrical noise/interference
2Exceeded wire length
3Poor connections

Resolution Steps

Check for sources of EMI, verify wire gauge and length, and ensure all shield drains are properly landed.

Manual References(1)

1notifierN16Installation2025Open

Field Notes

Loading field notes...

Sign in to share a field note

Related Codes

Cellular Card No ConnectivityThe cellular card is present but cannot connect to the cellular network.SELF TEST FAILEDAn automated diagnostic test on a detector or module has failed.AIO Address 1-10 Comm LossCommunication failure between the main panel and an AIO peripheral device.Charger Fail (LSB is PMB address 1-5)The power supply's battery charging circuit is not functioning correctly.AC Failure (LSB is PMB address 1-5)Loss of primary AC power to the power supply module.

Related Questions

How do I wire and configure ACM-30 annunciators on the N16, and what is the maximum number supported?How do I configure the N16 SLC loop for Class A vs. Class B wiring, and what is the maximum loop impedance allowed?What are the common trouble conditions displayed on the N16 touchscreen, and how do I navigate to view them?

All INSPIRE N16 trouble codes INSPIRE N16 panel page