DISABL: NFW2-100 Trouble Code | Fire Alarm Resource Center

What This Code Means

Input points which are disabled do not cause an alarm or any zone activation. Disabled output points are held in the off state. All disabled points are treated as if they were in trouble.

Common Causes

1A zone, NAC, detector or module has been temporarily disabled in programming by the user
2A detector or module has been set to 'Enabled No' in programming
3A software zone has been set to 'Disabled' in Zone Setup

Resolution Steps

To Enable or Disable the monitor module, press the 1 key while viewing the Edit Module Screen Each press of the key will toggle the screen between Enabled Yes and Enabled No.

Manual References(1)

1notifierNFW2-100Installation2005p. 127, 125, 130, 6, 2 +17Open

Related Codes

INVREPInvalid reply from the addressable device, indicating a hardware problem.COMM FAULT 1The control panel has failed 10 total attempts to communicate with the primary Central Station phone number.DUCT SUPERVISORYA supervisory condition has been triggered by a duct smoke detector.NAC 1 FAULTA fault condition (open or short) on Notification Appliance Circuit 1.DIRTY2Maintenance alert indicating that a detector needs immediate maintenance due to being within 80% of its alarm threshold for 24 hours.

Notifier NFW2-100

What This Code Means

Common Causes

Resolution Steps

Manual References(1)

Field Notes

Related Codes

Related Questions