Resource Center Tools

Sign In

Sign In

Home
Resources
Trouble Codes
Edwards Est
Io1000
014

Resource Center

Browse

Home Questions252 Trouble Codes688 Panels24 Panel Specs24

Learn

Community

Tools

Common Categories

System TroubleSupervisoryGround FaultNACCommunicationPowerDeviceNetwork

Troubleshooting Tip

When diagnosing codes, always check the event history log first. Many trouble conditions are intermittent and tied to environmental factors like temperature or moisture.

Recommended SupplierSponsored

Fire Alarm Parts for Old and New Systems

Panels, detectors, modules and signals
50+ brands, current and legacy
Order by 3 pm ET, ships same day
90-day warranty on every part

Shop Fire Alarm Parts

Can't find what you need?

Resource Center

Questions Panels Trouble Codes Panel Specs NFPA 72-2025

Legal

Privacy Policy Terms of Use Disclaimer DMCA

Cookie Preferences

Company

About Us Blog Glossary Contact Us

© FACP Manuals LLC. All rights reserved.

Built by Will

Loop 2 uncfgrd alarm: iO1000 Trouble Code | Fire Alarm Resource Center

Loop 2 uncfgrd alarm

alarm

Edwards EST iO1000

71 views·0 field notes

What This Code Means

A device on loop 2 that is not programmed went into alarm

Common Causes

1Unprogrammed smoke detector activated
2Unprogrammed pull station pulled
3Wrong device type installed

Resolution Steps

Identify the device in alarm, verify if it should be part of the system, and program it or remove it as necessary.

Manual References(3)

1edwards estiO64 and iO1000Datasheet2020p. 1Open

2edwards estiO64 and iO1000Datasheet2023p. 1Open

3edwards estiO64 and iO1000Installation2015p. 186, 160, 61, 187, 189 +2Open

Field Notes

Loading field notes...

Sign in to share a field note

Related Codes

Internal faultThe control panel detected an internal hardware or software error Dialer line 1 faultA ground fault or line fault was detected on line 1 of the dialer Dialer delivery failThe dialer failed to deliver a message to the receiver SupervisoryA supervisory event is taking place on the control panel, indicating an off-normal condition on a monitored circuit or device.Loop 1 uncfgrd troubleA device on loop 1 that is not programmed went into trouble

Related Questions

How do I address devices on the iO1000?How do I set up the SA-DACT dialer module in the iO1000 for dual-line DACT reporting using Contact ID format?What Signature series devices are compatible with the iO1000 SLC loop, and can I mix legacy and newer devices on the same loop?

All iO1000 trouble codes iO1000 panel page