FACP Manuals Logo
FACPManuals
Ask AI
Ask AI
Battery charger
trouble

Edwards EST iO1000

64 views·0 field notes

What This Code Means

The panel detected a battery charger trouble condition

Common Causes

  • 1Blown battery fuse
  • 2Failed charging circuit on the main board
  • 3Extremely discharged batteries

Resolution Steps

Check the battery fuses and measure the charging voltage. If the charger is not outputting the correct voltage, the main board may need replacement.

Manual References(3)

Field Notes

Loading field notes...
Sign in to share a field note

Related Codes

Internal faultThe control panel detected an internal hardware or software errorLoop 1 uncfgrd troubleA device on loop 1 that is not programmed went into troubleDialer line 1 faultA ground fault or line fault was detected on line 1 of the dialerSupervisoryA supervisory event is taking place on the control panel, indicating an off-normal condition on a monitored circuit or device.NAC 1 troubleAn open or short was detected on NAC 1 or there is a problem with the EOL

Related Questions

How do I address devices on the iO1000?How do I configure the iO1000 NAC circuits for Class A wiring instead of the default Class B?What Signature series devices are compatible with the iO1000 SLC loop, and can I mix legacy and newer devices on the same loop?
All iO1000 trouble codesiO1000 panel page