Waterflow: iO1000 Trouble Code | Fire Alarm Resource Center

What This Code Means

An input device programmed as a waterflow type has been activated, typically indicating water movement within the sprinkler system.

Common Causes

1Activation of a waterflow switch
2Sprinkler system activation
3Testing of the waterflow circuit
4Waterflow with retard activation

Resolution Steps

Input zones programmed as waterflow with retard require 10 to 15 seconds of activation to initiate the test signals. All device activations are latched until the panel is reset.

Manual References(2)

1edwards estiO64 and iO1000Installation2015p. 186, 160, 187, 61, 189 +15Open

2edwards estiO64 and iO1000Datasheet2020p. 6Open

Related Codes

Internal faultThe control panel detected an internal hardware or software error Dialer delivery failThe dialer failed to deliver a message to the receiver Dialer line 1 faultA ground fault or line fault was detected on line 1 of the dialer Loop 1 uncfgrd troubleA device on loop 1 that is not programmed went into trouble SupervisoryA supervisory event is taking place on the control panel, indicating an off-normal condition on a monitored circuit or device.

Edwards EST iO1000

What This Code Means

Common Causes

Resolution Steps

Manual References(2)

Field Notes

Related Codes

Related Questions