FACP Manuals Logo
FACPManuals
Ask AI
Ask AI
Hardware errortrouble

ESSER FlexES: Hardware error

ESSER FlexES·0 views·0 field notes

What This Code Means

Internal hardware failure detected within the essernet module.

Common Causes

  • 1Internal component failure
  • 2Physical damage to the module circuitry

Resolution Steps

Restart the module; if the error persists, replace the faulty essernet module.

Manual References(1)

Field Notes

Loading field notes...
Sign in to share a field note

Related Codes

Battery fault (excessive contact resistance)The system has detected excessive resistance (> 200 mOhm) at the battery terminals or cables.Wrong address settingThe essernet module has detected an invalid or conflicting address configuration after a restart.Tamper contactThe tamper contact is used to monitor whether the control panel's housing has been opened and can be used to automatically deactivate components for servicing.Fault in the mains power supplyThe primary 230 V AC power source is missing or has failed.Loop is too long or attenuation too highSignal strength is too low due to excessive loop length or high cable resistance.

Related Questions

How do I reset a fault condition on the Esser FlexES panel after replacing a detector on the loop?How do I set up cause-and-effect programming on the FlexES panel to link detector zones to NAC outputs?What are the compatible battery specifications for the FlexES panel, and what is the procedure for battery replacement?
All FlexES trouble codesFlexES panel page