FACP Manuals Logo
FACPManuals
Ask AI
Ask AI
Tamper contact
supervisory

ESSER FlexES

49 views·0 field notes

What This Code Means

The system has detected that a housing panel or door has been opened or tampered with.

Common Causes

  • 1Cabinet door left open
  • 2Tamper switch not properly depressed
  • 3Wiring fault to the tamper contact

Resolution Steps

Close and secure all cabinet doors and expansion housing panels; check the alignment of the tamper contact.

Manual References(1)

Field Notes

Loading field notes...
Sign in to share a field note

Related Codes

essernet connection interruptionA break or wiring error has been detected in the essernet communication loop.Tamper contactThe tamper contact is used to monitor whether the control panel's housing has been opened and can be used to automatically deactivate components for servicing.Wrong address settingThe essernet module has detected an invalid or conflicting address configuration after a restart.EARTH FAULTThe system has detected an unintended connection to ground or an incorrect configuration of the earth fault detection jumpers on multiple power supply modules.Battery FaultThe FACP indicates a fault when battery resistance is too high, voltage drops below the discharging limit, or a connection/fuse issue is detected.

Related Questions

How do I reset a fault condition on the Esser FlexES panel after replacing a detector on the loop?What do the common FlexES error codes mean, such as Loop Fault, Short Circuit, and Device Not Responding?What is the procedure for performing a walk test on the FlexES panel to verify detector and module operation?
All FlexES trouble codesFlexES panel page