Battery Fault: MS-9600 Trouble Code | Fire Alarm Resource Center

What This Code Means

The system has detected an issue with the standby batteries or their connection.

Common Causes

1Disconnected battery cables
2Low battery voltage
3Dead or failing battery cells

Resolution Steps

Check battery terminal connections for tightness and corrosion. Measure battery voltage; if below 21VDC, batteries may need replacement. Ensure batteries are not older than 3-5 years.

Manual References(6)

1fire-liteMS-9600LS and MS-9600UDLSInstallation2015p. 109Open

2fire-liteMS-9600Datasheet2007Open

3fire-liteMS-9600Datasheet2001Open

Related Codes

ACTIVE SUPERVISORYA condition indicating a state that needs attention but is not an alarm, such as a sprinkler valve tamper condition.DISABLIndicates that a zone, NAC, detector, or module has been temporarily disabled in programming by the user.AC PowerThe control panel has lost its primary 120VAC or 240VAC power source.Charger FaultThe internal battery charging circuit is not functioning correctly.Duplicate AddressThe system has detected more than one device sharing the same SLC address.

Fire-Lite MS-9600

What This Code Means

Common Causes

Resolution Steps

Manual References(6)

Field Notes

Related Codes

Related Questions