FACP Manuals Logo
FACPManuals
Ask AI
Ask AI
Type-Code Mismatchtrouble

Fire-Lite MS-9600: Type-Code Mismatch

Fire-Lite MS-9600·1 view·0 field notes

What This Code Means

The physical device installed at an address does not match the device type defined in the panel's memory.

Common Causes

  • 1Installing a heat detector where a smoke detector was programmed
  • 2Incorrect device selection during manual programming

Resolution Steps

Verify the physical model of the device at the reported address. Update the panel programming to match the device type or replace the device with the correct model.

Manual References(6)

Field Notes

Loading field notes...
Sign in to share a field note

Related Codes

AC LOSSThe control panel has lost its primary AC power supply and is currently operating on standby batteries.DISABLIndicates that a zone, NAC, detector, or module has been temporarily disabled in programming by the user.EARTH FAULTA ground fault condition indicating zero impedance between the Fire Alarm Control Panel and ground.Battery FaultThe system has detected an issue with the standby batteries or their connection.OPENThis condition indicates an open circuit on an addressable device (smoke detector, monitor module, or control module) connected to the Signaling Line Circuit (SLC) loop.

Related Questions

How do I set zone types on the MS-5024?How do I troubleshoot a Loop Fault or SLC Communication Failure on the MS-5024?How do I perform a walk test on the MS-5024 without triggering a full alarm?
All MS-9600 trouble codesMS-9600 panel page