Resource Center Tools

Sign In

Sign In

Home
Resources
Trouble Codes
Kidde
Fx 10
Waterflow Zone Active

Resource Center

Browse

Home Questions252 Trouble Codes688 Panels24 Panel Specs24

Learn

Community

Tools

Common Categories

System TroubleSupervisoryGround FaultNACCommunicationPowerDeviceNetwork

Troubleshooting Tip

When diagnosing codes, always check the event history log first. Many trouble conditions are intermittent and tied to environmental factors like temperature or moisture.

Recommended SupplierSponsored

Fire Alarm Parts for Old and New Systems

Panels, detectors, modules and signals
50+ brands, current and legacy
Order by 3 pm ET, ships same day
90-day warranty on every part

Shop Fire Alarm Parts

Can't find what you need?

Resource Center

Questions Panels Trouble Codes Panel Specs NFPA 72-2025

Legal

Privacy Policy Terms of Use Disclaimer DMCA

Cookie Preferences

Company

About Us Blog Glossary Contact Us

© FACP Manuals LLC. All rights reserved.

Built by Will

Waterflow zone active: FX-10 Trouble Code | Fire Alarm Resource Center

Waterflow zone active

supervisory

Kidde FX-10

64 views·0 field notes

What This Code Means

A waterflow switch has been activated, indicating water movement in the sprinkler system.

Common Causes

1Sprinkler head activation
2Water pressure surge
3System testing

Resolution Steps

Investigate the area for fire or water leakage. If no emergency exists, ensure the waterflow switch is restored and reset the panel.

Manual References(2)

1kiddeFX-5 and FX-10 SeriesOperating Instructions2017p. 1Open

2kiddeFX-5 and FX-10Installation2017p. 113, 86, 111, 65, 90 +3Open

Field Notes

Loading field notes...

Sign in to share a field note

Related Codes

Zone troubleAn open or short circuit condition exists on an Initiating Device Circuit (IDC).Ground faultA circuit has come into contact with earth ground.DACT Line 2 TrblA ground fault or line fault has been detected on the secondary telephone line.AC failurePrimary AC power to the control panel has been lost.NAC disabledA Notification Appliance Circuit has been manually taken out of service.

Related Questions

How do I set up zone-specific NAC activation on the FX-10 so that only certain horns/strobes activate for specific zones?How do I configure the Kidde FX-10 to pair IDC zones for Class A wiring?How do I wire and program the FX-10 onboard relays for connection to a building management system?

All FX-10 trouble codes FX-10 panel page