FX-10 Trouble Codes

Primary AC power to the control panel has been lost.

The panel detected a trouble condition or overload on the auxiliary power circuit.

The panel has detected that the standby batteries are low or failing a load test.

The control panel cannot detect the presence of standby batteries.

The panel's battery charging circuit is malfunctioning.

The dialer module is not programmed or contains unverified configuration changes.

The dialer failed to deliver a message to the central monitoring station receiver.

A ground fault or line fault has been detected on the primary telephone line.

A ground fault or line fault has been detected on the secondary telephone line.

A circuit has come into contact with earth ground.

An Initiating Device Circuit has been manually taken out of service.

The panel has lost communications with an internal component, typically the F-DACT1(F) dialer.

A Notification Appliance Circuit has been manually taken out of service.

A fault condition has been detected on a Notification Appliance Circuit.

The panel has lost communication with a peripheral device such as a remote annunciator.

A remote power supply or module has lost its primary AC power.

One or more Remote Relay Modules have been manually disabled.

A supervisory device, such as a valve tamper switch, has been activated.

A system test was performed and an abnormal condition was detected.

A fault has been detected with the secondary power transformer.

A waterflow switch has been activated, indicating water movement in the sprinkler system.

An open or short circuit condition exists on an Initiating Device Circuit (IDC).