FACP Manuals Logo
FACPManuals
Ask AI
Ask AI
DATA LOST
trouble

Silent Knight SK-5207

72 views·0 field notes

What This Code Means

The communicator has lost data that was being transmitted to the central station, or the alarm memory buffer is full.

Common Causes

  • 1Communicator lost data during transmission to the central station
  • 2Total attempts to communicate have been made without success
  • 3Alarm memory buffer is full

Resolution Steps

Press [ENTER] + code to clear the alarm memory buffer.

Manual References(3)

Field Notes

Loading field notes...
Sign in to share a field note

Related Codes

A2A trouble condition exists on notification circuit 2 (bell output 2), or the power supply and panel voltage selections are not the same.F3This code indicates a trouble condition with remote annunciator number 3 on the system bus.BUS TROUBLEThe annunciator data wires are shorted or reversed.FAILED DFThe communicator has failed to report an event to the central station after the programmed number of attempts have been made.A3Indicates a trouble condition on notification circuit 3 or that the power supply and panel voltage selections are not the same.

Related Questions

How do I wire Class B vs. Class A zone loops on the SK-5207, and what end-of-line resistor value is required?How do I program Relay 3 on the SK-5207 to activate on all trouble conditions?Which two-wire and four-wire smoke detectors are compatible with the SK-5207?
All SK-5207 trouble codesSK-5207 panel page