FACP
Manuals
Resource Center
Tools
Ask AI
Sign In
Ask AI
Sign In
Home
•••
Resources
Trouble Codes
Fenwal
Fenwalnet 6000
Addr Low Airflow
Resource Center
Browse
Home
Questions
252
Trouble Codes
688
Panels
24
Panel Specs
24
Learn
NFPA 72-2025
Community
Community Wall
Tools
Ask AI
Addr Low Airflow On AnaLASER Interface Module: FENWALNET 6000 Trouble Code | Fire Alarm Resource Center
Addr Low Airflow On AnaLASER Interface Module
trouble
Fenwal FENWALNET 6000
65 views
·
0 field notes
What This Code Means
Low air flow detected through the piping system of a high-sensitivity smoke detector (HSSD).
Common Causes
1
Clogged sampling holes
2
Blocked piping
3
Aspirator pump failure
Resolution Steps
Inspect piping for blockages and check sampling holes for dust or debris. Use LaserNET to troubleshoot the airflow levels.
Manual References
(1)
1
fenwal
FENWALNET 6000
Installation
2004
p. 16, 25, 170, 11, 175 +4
Open
Getting Addr Low Airflow On AnaLASER Interface Module on your FENWALNET 6000?
Ask TroubleShooter AI for help
→
Field Notes
Loading field notes...
Sign in
to share a field note
Related Codes
Addr Input Trouble On Monitor Module
An open circuit has been detected in a monitor module's initiating device circuit (IDC).
AR1 Short Circuit Trouble On
A short circuit has been detected in the field wiring connected to the main circuit board terminal TB12.
24-Hour Trouble Reminder Message
A reminder that a trouble condition has been active and silenced for 24 hours without being resolved.
Addr Line Volt Fault On Device Type
A failure of the DC to DC converter in the device at the specified address, or insufficient voltage reaching the device.
AR2 Open Circuit Trouble On
An open circuit has been detected in the field wiring connected to the main circuit board terminal TB11.
Related Questions
How do I navigate the FENWALNET 6000 panel interface to view active alarms, troubles, and supervisory conditions?
What are the pre-discharge and discharge sequences on the FenwalNET-6000 suppression system, and how does the abort function work?
How do I program addressable devices into the FENWALNET 6000 panel, and what software is required?
