FACP Manuals Logo
FACPManuals
Ask AI
Ask AI
Alarm Events Buffer Full Message
maintenance

Fenwal FENWALNET 6000

51 views·0 field notes

What This Code Means

The internal buffer for alarm events has reached its maximum capacity.

Common Causes

  • 1Multiple simultaneous alarm conditions
  • 2Failure to reset the panel after multiple alarms

Resolution Steps

Acknowledge all alarm events and reset the control unit once the conditions are cleared.

Manual References(1)

Field Notes

Loading field notes...
Sign in to share a field note

Related Codes

AR1 Short Circuit Trouble OnA short circuit has been detected in the field wiring connected to the main circuit board terminal TB12.24-Hour Trouble Reminder MessageA reminder that a trouble condition has been active and silenced for 24 hours without being resolved.AR2 Open Circuit Trouble OnAn open circuit has been detected in the field wiring connected to the main circuit board terminal TB11.Addr Input Trouble On Monitor ModuleAn open circuit has been detected in a monitor module's initiating device circuit (IDC).Addr Line Volt Fault On Device TypeA failure of the DC to DC converter in the device at the specified address, or insufficient voltage reaching the device.

Related Questions

How do I navigate the FENWALNET 6000 panel interface to view active alarms, troubles, and supervisory conditions?What are the pre-discharge and discharge sequences on the FenwalNET-6000 suppression system, and how does the abort function work?What is the SLC loop wiring configuration for the FENWALNET 6000, and does it support Class A and Class B?
All FENWALNET 6000 trouble codesFENWALNET 6000 panel page