Resource Center Tools

Sign In

Sign In

Home
Resources
Trouble Codes
Fenwal
Fenwalnet 6000
Ar2 Short Circuit

Resource Center

Browse

Home Questions252 Trouble Codes688 Panels24 Panel Specs24

Learn

Community

Tools

Common Categories

System TroubleSupervisoryGround FaultNACCommunicationPowerDeviceNetwork

Troubleshooting Tip

When diagnosing codes, always check the event history log first. Many trouble conditions are intermittent and tied to environmental factors like temperature or moisture.

Recommended SupplierSponsored

Fire Alarm Parts for Old and New Systems

Panels, detectors, modules and signals
50+ brands, current and legacy
Order by 3 pm ET, ships same day
90-day warranty on every part

Shop Fire Alarm Parts

Can't find what you need?

Resource Center

Questions Panels Trouble Codes Panel Specs NFPA 72-2025

Legal

Privacy Policy Terms of Use Disclaimer DMCA

Cookie Preferences

Company

About Us Blog Glossary Contact Us

© FACP Manuals LLC. All rights reserved.

Built by Will

AR2 Short Circuit Trouble On: FENWALNET 6000 Trouble Code | Fire Alarm Resource Center

AR2 Short Circuit Trouble On

trouble

Fenwal FENWALNET 6000

66 views·0 field notes

What This Code Means

A short circuit has been detected in the field wiring connected to the main circuit board terminal TB11.

Common Causes

1Pinched wires in the enclosure
2Shorted release device
3Wiring fault

Resolution Steps

Troubleshoot Release-2 wiring by breaking-up the circuit to isolate the short circuit to a specific leg.

Manual References(1)

1fenwalFENWALNET 6000Installation2004p. 16, 25, 170, 11, 175 +4Open

Field Notes

Loading field notes...

Sign in to share a field note

Related Codes

Addr Input Trouble On Monitor ModuleAn open circuit has been detected in a monitor module's initiating device circuit (IDC).AR1 Short Circuit Trouble OnA short circuit has been detected in the field wiring connected to the main circuit board terminal TB12.24-Hour Trouble Reminder MessageA reminder that a trouble condition has been active and silenced for 24 hours without being resolved.Addr Line Volt Fault On Device TypeA failure of the DC to DC converter in the device at the specified address, or insufficient voltage reaching the device.AR2 Open Circuit Trouble OnAn open circuit has been detected in the field wiring connected to the main circuit board terminal TB11.

Related Questions

How do I navigate the FENWALNET 6000 panel interface to view active alarms, troubles, and supervisory conditions?What are the pre-discharge and discharge sequences on the FenwalNET-6000 suppression system, and how does the abort function work?How do I program addressable devices into the FENWALNET 6000 panel, and what software is required?

All FENWALNET 6000 trouble codes FENWALNET 6000 panel page