Resource Center Tools

Sign In

Sign In

Home
Resources
Trouble Codes
Fire Lite
Ms 5024
Failed Up Download

Resource Center

Browse

Home Questions252 Trouble Codes688 Panels24 Panel Specs24

Learn

Community

Tools

Common Categories

System TroubleSupervisoryGround FaultNACCommunicationPowerDeviceNetwork

Troubleshooting Tip

When diagnosing codes, always check the event history log first. Many trouble conditions are intermittent and tied to environmental factors like temperature or moisture.

Recommended SupplierSponsored

Fire Alarm Parts for Old and New Systems

Panels, detectors, modules and signals
50+ brands, current and legacy
Order by 3 pm ET, ships same day
90-day warranty on every part

Shop Fire Alarm Parts

Can't find what you need?

Resource Center

Questions Panels Trouble Codes Panel Specs NFPA 72-2025

Legal

Privacy Policy Terms of Use Disclaimer DMCA

Cookie Preferences

Company

About Us Blog Glossary Contact Us

© FACP Manuals LLC. All rights reserved.

Built by Will

Failed Up/Download: MS-5024 Trouble Code | Fire Alarm Resource Center

Failed Up/Download

trouble

Fire-Lite MS-5024

69 views·0 field notes

What This Code Means

The panel failed to complete a remote programming upload or download session.

Common Causes

1Phone line interruption during transfer
2Incorrect upload/download password
3Modem handshake failure

Resolution Steps

Verify the connection and retry the upload/download from the remote PC. Ensure the panel is not in a local programming mode.

Manual References(4)

1fire-liteMS-5024Installation1997Open

2fire-liteMS-5024UDInstallation1997Open

3fire-liteMS-5024Operating Instructions1994Open

Field Notes

Loading field notes...

Sign in to share a field note

Related Codes

Bell 1 circuit faultA fault condition (open or short) exists on Notification Appliance Circuit 1.Annunciator FaultCommunication has been lost between the main control panel and a remote annunciator.AC Loss (shown only when requested)The AC ON indicator turns off and the trouble LED turns on when the AC line voltage drops below the Low Line threshold.Ground faultThe control panel has detected that a supervised circuit, such as a zone or NAC, is in contact with earth ground.SUPX (X=Zone Number)A condition indicating that a waterflow sensing device, its wiring, or a tamper switch is in an off-normal state.

Related Questions

How do I perform a walk test on the MS-5024 without triggering a full alarm?How do I set zone types on the MS-5024?What is the maximum SLC loop capacity of the MS-5024, and which Fire-Lite detectors and modules are compatible?

All MS-5024 trouble codes MS-5024 panel page