SUPX (X=Zone Number)supervisory

Fire-Lite MS-5024: SUPX (X=Zone Number)

Fire-Lite MS-5024·0 views·0 field notes

What This Code Means

A condition indicating that a waterflow sensing device, its wiring, or a tamper switch is in an off-normal state.

Common Causes

1Wiring to the waterflow valve or tamper switch has been cut
2Tamper switch has been activated
3Waterflow sensing device activation

Resolution Steps

When the supervisory condition has been cleared (condition is restored and the reset switch has been pressed) the control panel will turn off the supervisory LED, deactivate the supervisory relay(s), clear the display of the SUP message, and shut off the piezo sounder. Note: For any zone programmed for Supervisory auto resettable, the Reset key does not need to be pressed to clear the zone.

Manual References(5)

1fire-liteMS-5024Installation1997Open

2fire-liteMS-5024UDInstallation1997Open

3fire-liteMS-5024Installation2002p. 50, 71Open

Field Notes

Loading field notes...

Related Codes

System Off NormalThe system is in a non-standard operating mode, such as Troubleshoot or Programming mode.Primary Phone Line FaultThe panel has detected a loss of voltage or connection on the primary telephone line.AC Loss (shown only when requested)The AC ON indicator turns off and the trouble LED turns on when the AC line voltage drops below the Low Line threshold.Ground faultThe control panel has detected that a supervised circuit, such as a zone or NAC, is in contact with earth ground.Bell 1 circuit faultA fault condition (open or short) exists on Notification Appliance Circuit 1.