FACP
Manuals
Resource Center
Tools
Ask AI
Sign In
Ask AI
Sign In
Home
•••
Resources
Trouble Codes
Fire Lite
Ms 5024
Zone N Alarm
Resource Center
Browse
Home
Questions
252
Trouble Codes
688
Panels
24
Panel Specs
24
Learn
NFPA 72-2025
Community
Community Wall
Tools
Ask AI
Alarm Zone # n: MS-5024 Trouble Code | Fire Alarm Resource Center
Alarm Zone # n
alarm
Fire-Lite MS-5024
61 views
·
0 field notes
What This Code Means
An initiating device on the specified zone has entered the alarm state.
Common Causes
1
Smoke or heat detection
2
Manual pull station activation
3
Waterflow switch activation
Resolution Steps
Evacuate the area and notify the fire department. Once the cause is cleared, reset the initiating device and press the panel RESET key.
Manual References
(4)
1
fire-lite
MS-5024
Installation
1997
Open
2
fire-lite
MS-5024UD
Installation
1997
Open
3
fire-lite
MS-5024
Operating Instructions
1994
Open
Show 1 more reference
Getting Alarm Zone # n on your MS-5024?
Ask TroubleShooter AI for help
→
Field Notes
Loading field notes...
Sign in
to share a field note
Related Codes
Bell 1 circuit fault
A fault condition (open or short) exists on Notification Appliance Circuit 1.
Annunciator Fault
Communication has been lost between the main control panel and a remote annunciator.
AC Loss (shown only when requested)
The AC ON indicator turns off and the trouble LED turns on when the AC line voltage drops below the Low Line threshold.
Ground fault
The control panel has detected that a supervised circuit, such as a zone or NAC, is in contact with earth ground.
SUPX (X=Zone Number)
A condition indicating that a waterflow sensing device, its wiring, or a tamper switch is in an off-normal state.
Related Questions
How do I perform a walk test on the MS-5024 without triggering a full alarm?
How do I set zone types on the MS-5024?
What is the maximum SLC loop capacity of the MS-5024, and which Fire-Lite detectors and modules are compatible?
