FACP
Manuals
Resource Center
Tools
Ask AI
Sign In
Ask AI
Sign In
Home
•••
Resources
Trouble Codes
Fire Lite
Ms 5024
Zone N Disabled
Resource Center
Browse
Home
Questions
252
Trouble Codes
688
Panels
24
Panel Specs
24
Learn
NFPA 72-2025
Community
Community Wall
Tools
Ask AI
Zone n disabled: MS-5024 Trouble Code | Fire Alarm Resource Center
Zone n disabled
maintenance
Fire-Lite MS-5024
58 views
·
0 field notes
What This Code Means
The specified initiating zone has been manually disabled and will not report alarms.
Common Causes
1
Manual disablement for system service
2
Programming error
Resolution Steps
Re-enable the zone through the panel programming or keypad interface to restore protection.
Manual References
(4)
1
fire-lite
MS-5024
Installation
1997
Open
2
fire-lite
MS-5024UD
Installation
1997
Open
3
fire-lite
MS-5024
Operating Instructions
1994
Open
Show 1 more reference
Getting Zone n disabled on your MS-5024?
Ask TroubleShooter AI for help
→
Field Notes
Loading field notes...
Sign in
to share a field note
Related Codes
Bell 1 circuit fault
A fault condition (open or short) exists on Notification Appliance Circuit 1.
Annunciator Fault
Communication has been lost between the main control panel and a remote annunciator.
AC Loss (shown only when requested)
The AC ON indicator turns off and the trouble LED turns on when the AC line voltage drops below the Low Line threshold.
SUPX (X=Zone Number)
A condition indicating that a waterflow sensing device, its wiring, or a tamper switch is in an off-normal state.
Ground fault
The control panel has detected that a supervised circuit, such as a zone or NAC, is in contact with earth ground.
Related Questions
How do I perform a walk test on the MS-5024 without triggering a full alarm?
How do I set zone types on the MS-5024?
What is the maximum SLC loop capacity of the MS-5024, and which Fire-Lite detectors and modules are compatible?
