Resource Center Tools

Sign In

Sign In

Home
Resources
Trouble Codes
Kidde
Aegis 2 0
002

Resource Center

Browse

Home Questions252 Trouble Codes688 Panels24 Panel Specs24

Learn

Community

Tools

Common Categories

System TroubleSupervisoryGround FaultNACCommunicationPowerDeviceNetwork

Troubleshooting Tip

When diagnosing codes, always check the event history log first. Many trouble conditions are intermittent and tied to environmental factors like temperature or moisture.

Recommended SupplierSponsored

Fire Alarm Parts for Old and New Systems

Panels, detectors, modules and signals
50+ brands, current and legacy
Order by 3 pm ET, ships same day
90-day warranty on every part

Shop Fire Alarm Parts

Can't find what you need?

Resource Center

Questions Panels Trouble Codes Panel Specs NFPA 72-2025

Legal

Privacy Policy Terms of Use Disclaimer DMCA

Cookie Preferences

Company

About Us Blog Glossary Contact Us

© FACP Manuals LLC. All rights reserved.

Built by Will

002: Aegis 2.0 Trouble Code | Fire Alarm Resource Center

002

trouble

Kidde Aegis 2.0

83 views·0 field notes

What This Code Means

AC Voltage is below 85% of nominal

Common Causes

1Brownout condition
2Loss of primary AC power
3Blown AC fuse

Resolution Steps

Check incoming AC power and ensure it is within the required operating range.

Manual References(2)

1kiddeAEGIS 2.0Installation2015p. 75, 76, 9, 77, 72 +2Open

2kiddeAEGIS 2.0Datasheet2016p. 3, 6, 1Open

Field Notes

Loading field notes...

Sign in to share a field note

Related Codes

027ARC 2 Not Open Circuit (Unexpected load detected)020Notification Appliance Circuit (NAC) 3 short circuit System SupervisoryThe control unit has detected a change in state of one or both of its supervisory input circuits, or its PCB mounted Output Disable switch.001 GroundThe control unit has detected an unintended connection to earth ground on the field wiring.024Notification Appliance Circuit (NAC) 2 open circuit

Related Questions

How do I program the Kidde Aegis 2.0 cross-zone detection so that two circuits must activate before the releasing circuit fires?What is the correct procedure to test the manual release function on the Aegis 2.0 without discharging the agent?What is the difference between Abort Mode 1 (UL 864) and Abort Mode 3 (IRI) on the Aegis 2.0?

All Aegis 2.0 trouble codes Aegis 2.0 panel page