FACP Manuals Logo
FACPManuals
Ask AI
Ask AI
P0
trouble

Silent Knight SK-5207

55 views·0 field notes

What This Code Means

The built-in touchpad displays this code to indicate that the system printer is out of paper.

Common Causes

  • 1Printer has run out of paper
  • 2Printer is enabled in system programming (Step 1) but is not ready to print

Resolution Steps

Check the printer connected to the system and replenish the paper supply.

Manual References(3)

Field Notes

Loading field notes...
Sign in to share a field note

Related Codes

A2A trouble condition exists on notification circuit 2 (bell output 2), or the power supply and panel voltage selections are not the same.F3This code indicates a trouble condition with remote annunciator number 3 on the system bus.BUS TROUBLEThe annunciator data wires are shorted or reversed.FAILED DFThe communicator has failed to report an event to the central station after the programmed number of attempts have been made.DATA LOSTThe communicator has lost data that was being transmitted to the central station, or the alarm memory buffer is full.

Related Questions

How do I wire Class B vs. Class A zone loops on the SK-5207, and what end-of-line resistor value is required?How do I program Relay 3 on the SK-5207 to activate on all trouble conditions?Which two-wire and four-wire smoke detectors are compatible with the SK-5207?
All SK-5207 trouble codesSK-5207 panel page