FACP Manuals Logo
FACPManuals
Ask AI
Ask AI
Walk Test Active in Systemtrouble

Simplex 4010ES: Walk Test Active in System

Simplex 4010ES·0 views·0 field notes

What This Code Means

The system is currently in Walk Test mode.

Common Causes

  • 1Technician initiated Walk Test
  • 2Test mode not exited after service

Resolution Steps

Exit the Walk Test mode through the system menus to return the panel to normal operation.

Manual References(5)

Field Notes

Loading field notes...
Sign in to share a field note

Related Codes

Maintenance Switch SupervisoryA maintenance switch has been activated to allow the system to be tested or serviced without actuating fire suppression.FIRE MONITOR ZONE OPEN CIRCUIT TROUBLEA trouble message used to indicate that the FACP is impaired due to a break in the electrical path of a circuit.SUPERVISORYA Supervisory condition indicates that some part of the building’s fire protection system is disabled or a lower priority initiating device has been triggered.IDNet Device: M#-# Battery FaultThis trouble indicates that there is a battery failure on the 4009 IDNet NAC Extender device connected to the system.[Point Label] DISABLED TROUBLEA point or zone has been manually inhibited from reporting alarm conditions or other status changes, typically because the device is malfunctioning or undergoing maintenance.

Related Questions

What are the NAC circuit specifications for the Simplex 4010ES, and how many notification appliance circuits does it support?How do I troubleshoot a ground fault on the Simplex 4100ES using the Earth Fault Search?How do I troubleshoot a ground fault on the Simplex 4010ES?
All 4010ES trouble codes4010ES panel page