FACP Manuals Logo
FACPManuals
Ask AI
Ask AI
Duct Smoke Supervisorysupervisory

Simplex 4010ES: Duct Smoke Supervisory

Simplex 4010ES·0 views·0 field notes

What This Code Means

A duct smoke detector has been triggered, typically configured as a supervisory event rather than an alarm.

Common Causes

  • 1Smoke in HVAC ducts
  • 2Dust or dirt in the detector
  • 3Airflow issues

Resolution Steps

Check the HVAC system for smoke; clean the detector and reset the panel.

Manual References(5)

Field Notes

Loading field notes...
Sign in to share a field note

Related Codes

SUPERVISORYA Supervisory condition indicates that some part of the building’s fire protection system is disabled or a lower priority initiating device has been triggered.Maintenance Switch SupervisoryA maintenance switch has been activated to allow the system to be tested or serviced without actuating fire suppression.FIRE MONITOR ZONE OPEN CIRCUIT TROUBLEA trouble message used to indicate that the FACP is impaired due to a break in the electrical path of a circuit.IDNet Device: M#-# Battery FaultThis trouble indicates that there is a battery failure on the 4009 IDNet NAC Extender device connected to the system.Abort Switch ActiveAn abort switch has been activated, preventing the release of suppression agents.

Related Questions

What are the NAC circuit specifications for the Simplex 4010ES, and how many notification appliance circuits does it support?How do I troubleshoot a ground fault on the Simplex 4100ES using the Earth Fault Search?How do I troubleshoot a ground fault on the Simplex 4010ES?
All 4010ES trouble codes4010ES panel page