Notifier INSPIRE N16 Questions
Questions and answers specific to the Notifier INSPIRE N16.
Sign in to ask a question
Questions and answers specific to the Notifier INSPIRE N16.
Replace batteries every 5 years or if terminal voltage drops below 21.6 VDC during a load test (Page 59) [1]. The N16 reports battery issues through a yellow...
To program the N16 offline, create the system database on a PC running VeriFire Tools (Windows 10 or newer, 64-bit) before connecting to the panel for download...
To run the Autoprogram feature on the N16, navigate to the Programming menu and select Autoprogram [7]. This feature identifies addressable detectors and...
To conduct a walk test on the N16 panel, you must use the touchscreen interface to access the Walk Test Menu, where you can choose between Basic and Advanced...
Common trouble conditions on the N16 include AC Failure, Battery Low or Missing, Earth Fault, Charger Fail, and Communication Loss for SLC loops or AIO...
To set detector sensitivity on the N16, use point programming or VeriFire Tools to select a level from 1 (most sensitive) to 9 (least sensitive) for both alarm...
The N16 supports a maximum of 80 ACM-30 annunciators connected via the AIO Bus (Page 1) [1]. Wiring requires four wires: two for EIA-485 communications...
To program Self-Test detectors, you must assign the specific FlashScan Type Code (such as FSP-951-SELFT) using VeriFire Tools or the panel's Autoprogram...
To configure the N16 SLC loop, you must program the NFPA class configuration into the panel software; the system will automatically check for a mismatch...
To set up the CLSS Gateway (CGW-MB) for cloud connectivity and remote programming, you must physically install the module and activate the required cloud...