iO64 Trouble Codes

A device on loop 1 that is not programmed went into alarm.

A device on loop 1 that is not programmed went into trouble.

The loop 1 map in RAM and the loop 1 map in the database do not match.

There are too many devices on loop 1.

A device on loop 1 has an address set to zero.

A short or open was detected on loop 2 affecting the communications between the panel and the devices on the loop.

A mapping fault was detected on loop 2 while the panel was mapping the devices.

The loop 2 card is not present or it is not working.

The panel detected a ground fault.

The panel detected a battery charger trouble condition; the charger may not be able to charge the batteries.

The batteries are low on power.

The battery is no longer connected.

There is a problem with the panel’s AC power.

The control panel detected a trouble condition on the continuous AUX power circuit 1.

The control panel detected a trouble condition on the resettable AUX power circuit 2.

A fault was detected while testing the panel’s internal subsystems (memory, flash, code).

The control panel detected an internal hardware or software error.

A ground fault or line fault was detected on line 1 of the dialer.

The dialer failed to deliver a message to the receiver.

The dialer is not programmed or has unverified configuration.

Communications between the panel and network receiver 01 failed.

IP Gateway configuration is invalid.

Firmware update failed to store the Image.bin into panel flash memory.

An open or short was detected on NAC 1 or there is a problem with the EOL.

The printer is either offline, out of paper, or disconnected.

An open or short was detected on annunciator 1.

A waterflow condition has been detected, indicating water movement in the sprinkler system.

A supervisory condition has been detected by the system.

A maintenance alert was detected for a zone.