4100ES Trouble Codes

AC power is not present or is too low for proper system operation.

This condition indicates that the building's notification appliances have been manually silenced while an alarm or warning condition is still active on the panel.

A supervisory condition specifically for a controlled damper.

An exhaust system supervisory condition has been detected.

A complete communication failure has occurred on a specific system channel or loop.

A break in the wiring has occurred on a Class A (Style 6 or 7) circuit.

A Carbon Monoxide Fire Alarm condition has been detected.

A Carbon Monoxide Priority 2 event has been detected.

A Carbon Monoxide supervisory condition is active.

A pressure-related supervisory condition is active.

A fire or smoke damper is not in its normal operating position.

A point has been manually suppressed and will not report alarm conditions or other status changes; the system indicates a trouble condition for each disabled point.

The panel is actively performing a search to locate and isolate a ground fault.

A device is responding at an address that has not been programmed into the system configuration.

A standard fire alarm condition has been triggered.

A circuit has developed an electrical path to the earth ground.

Gate Valve Monitor supervisory condition.

The IDNet card has detected an issue with its internal or loop power monitoring.

The system is in Install Mode, which groups troubles for uninstalled devices into a single condition.

A latching supervisory condition has been detected that requires a manual reset.

A programmed device is either not responding or is sending invalid data to the panel.

During a TrueAlert ES self-test, no light or sound output was detected from the appliance.

The TrueAlert ES appliance did not return a test result before the self-test cycle ended.

An output circuit, such as a NAC, is not in its expected electrical state.

The system diagnostic LED is currently active, indicating a diagnostic process is running or a hardware fault is being signaled.

The system failed to poll transponders during a BMUX override condition.

The Carbon Monoxide (CO) sensor is approximately 6 months away from its expiration date.

The Carbon Monoxide (CO) sensor is approximately 12 months away from its expiration date.

Indicates that cleared troubles have been globally acknowledged in the system log.

Supervisory verification group 0 is currently active and processing a point state change.

Supervisory verification group 1 is currently active and processing a point state change.

Supervisory verification group 2 is currently active and processing a point state change.

Supervisory verification group 3 is currently active and processing a point state change.

Supervisory verification group 4 is currently active and processing a point state change.

Supervisory verification group 5 is currently active and processing a point state change.

Supervisory verification group 6 is currently active and processing a point state change.

Supervisory verification group 7 is currently active and processing a point state change.

The system has activated a filter to suppress recurring intermittent trouble signals to prevent nuisance notifications.

A water-related supervisory condition has been detected.

This message appears when a short circuit is detected on the IDNet or IDNAC channel.

A trouble or supervisory condition related to a damper has been detected.

The installed appliance is not compatible with the TrueAlert ES Self-Test feature.

The system is currently in a test mode that allows for automatic resetting of alarms.

Waterflow has been detected in the sprinkler system.

This condition indicates that a waterflow device connected to a monitor zone has been activated, typically by water moving through the sprinkler system.

Waterflow Supervisory Closed condition.

Waterflow Supervisory Open condition.