VISTA-128FBP Trouble Codes

27 trouble codes for the Honeywell VISTA-128FBP

CHECK or TRBL 6XX

Indicates a trouble condition on a supervised relay where XX is the relay number (01-32).

CHECK or TRBL 8XX

Indicates a trouble on a peripheral device connected to the panel's keypad terminals where XX is the device address (00-30).

CHECK or TRBL 970

Trouble detected on Bell 1 Output (Notification Appliance Circuit).

CHECK or TRBL 971

Trouble detected on Bell 2 Output (Notification Appliance Circuit).

972 Earth Ground Fault

A system trouble indicating that an earth ground fault has been detected. This condition may eliminate some of the system's protection.

CHECK or TRBL 973

Trouble detected on the J2 Trigger Output.

CHECK or TRBL 974

Trouble detected on Dialer 1.

CHECK or TRBL 975

Trouble detected on Dialer 2.

CHECK or TRBL 988

The 2nd RF Receiver is not receiving signals.

CHECK or TRBL 990

The 1st RF Receiver is not receiving signals.

CHECK or TRBL 997

Polling Loop Short circuit detected.

The system has lost primary AC power and the keypad is operating on battery power only.

Indicates that a burglary or non-fire protection zone has been faulted while the system is armed, or a 24-hour zone has been triggered.

CHECK or TRBL CALL SERVICE

A problem exists with the system that eliminates some of the protection.

Indicates a trouble condition in the system, which may be associated with specific zones, supervised relays, peripheral devices, or system components like dialers and ground faults.

Indicates a trouble condition in the system, meaning a problem exists with specific zones, relays, peripheral devices, or system components that may eliminate some protection.

CHECK or TRBL accompanied by zone descriptor

A problem exists with the specific zone(s) displayed, which may include Fire or Waterflow zones.

A failure has occurred in the telephone communication portion of the system.

A fire emergency has been detected by smoke or heat detectors, or has been manually initiated via a panic key.

FIRE DRILL ACTIVE

The system is currently in Fire Drill test mode.

HSENS accompanied by zone number

A smoke detector has a high sensitivity level, which may cause false alarms.

LO BAT accompanied by zone descriptor

A low battery condition exists in the displayed wireless transmitter.

LSENS accompanied by zone number

A smoke detector has a low sensitivity level and might not detect smoke.

FIRE or ALARM accompanied by zone descriptor

Indicates that an alarm occurred while the system was armed.

The control panel is currently communicating with the central station's remote computer.

This display indicates a problem on fire supervisory zone(s), which means that the operation of the fire alarm system may be compromised.

The system's main backup battery is low.

VISTA-128FBP panel page